Home Made Parrot Tree

The size described is what I felt I needed for my flock. Depending upon your needs and the size you can accommodate you may want to make the play stand tray larger or smaller.

The instructions given describe the tray area and the method used to attach the trees.

The support or leg structure used was an old table that I purchased at a garage sale for $10. The tray with the trees attached was bolted to the table by drilling 4 holes holes through the tree tray and table and securing the two with 3/8" diameter, 2 1/2" long stainless steel bolts, nuts and washers.

Tray Construction

1. With the skill saw or table saw, cut a 3" piece off of each side of the plywood. If you are using a skill saw you should use a guide to insure a straight cut. These pieces will be used to make the raised edges around the sides of the tray area.

2. Pre-dill the edges of the plywood base to accommodate screws that will be used to fasten the raised edges to the base. Dill the holes about 10" apart.

3. Run a bead of wood glue along the plywood base edges where the raised edges are going to be fastened.

4. Fasten the raised edges to the base using 1" wood screws.

5. Paint the tray with several coats of latex paint.

6. Drill 3/8" diameter holes in the tray where the base of the branch or branches will be located.

Tree Branch Preparation

1. I obtained my branches from the local forest. I picked branches that had the shape I wanted insuring that the base of the branch was approximately 3" in diameter.

2. Drill a 5/16" diameter, 2 1/2" deep (aprox) hole the base of the branch

3. Secure the branches to the tray using lag bolt